SETUP AND ADJUSTMENTS
Begin with either side and put the motion control lever into the neutral position. Adjust the motion control linkage by rotating the double nuts in the proper direction until the wheel stops rotating. FIG - 7 Move the motion control lever forward then into the neutral position and place it into the neutral slot. The wheel must be stopped com- pletely at this point. Now do the same in reverse and release the lever. The lever should return to neutral on its own.
Motion |
| |
Control | Turn Here | |
Lever | ||
To Adjust | ||
| ||
| Pump | |
| Arm | |
Loosen Here | Loosen Here | |
| ||
(Lt. Hand Thds.) |
| |
FIG - 7 |
|
Run engine full throttle to make sure wheels do not rotate. Readjust if any rotation occurs.
Repeat the whole process for the opposite side and tighten the nuts against the ball joints.
Turn machine off.
Reinstall the seat rod and check the wiring har- ness to the seat safety switch for a good connec- tion and return the seat to the normal position.
19