STARTING AND STOPPING
Starting and stopping
WARNING! Note the following before
!starting:
The machine should be connected to an earthed outlet socket.
Check that the mains voltage corresponds with that stated on the rating plate on the machine.
Make sure you have a secure footing and that the cutting blade cannot touch anything.
Keep people and animals well away from the working area.
Before starting (K3000 Wet)
Water connector
Connect the water hose to the water supply (A). The water flow is regulated using the water tap (B).
Ground fault circuit interrupter
Make sure the ground fault circuit interrupter is switched on. The LED indicates that the ground fault circuit interrupter is on and that the machine can be switched on. If the LED is not on, push the RESET button (green).
Check the ground fault circuit interrupter. See instructions under the heading Checking, maintaining and servicing the machine’s safety equipment.
Starting
•Grip the front handle with the left hand.
•Grip the rear handle with your right hand.
•Press in the power switch lock with your
•Run the machine unloaded and in a safe manner for at least 30 seconds.
Stopping
WARNING! The cutting blade continues to
!rotate for some time after the motor has stopped.
Stop the motor by releasing the power switch.
English – 15
