STARTING AND STOPPING
Before starting
WARNING! Please read the operator’s
!manual carefully and make sure you understand the instructions before using the machine.
Wear personal protective equipment. See instructions under the heading ”Personal protective equipment”.
Make sure no unauthorised persons are in the working area, otherwise there is a risk of serious personal injury.
Check that the fuel cap is properly secured, and that there is no fuel leakage. Risk of fire.
•Perform daily maintenance. See instructions in the section "Maintenance".
Starting
•Decompression valve: Press in the valve to reduce the pressure in the cylinder, this is to assist starting the power cutter. The decompression valve should always be used when starting. The valve automatically returns to its initial position when the machine starts.
•Stop switch: Make sure that the stop switch (STOP) is in the left position.
•Start throttle position - cold engine: Start throttle position and choke is obtained by pulling out the choke completely.
•Start throttle position - warm engine: The correct choke/start throttle setting is obtained by pulling the choke control to the choke position and then pushing it in again. This only engages the start throttle setting without any choke.
•Air purge: Press the air purge diaphragm repeatedly until fuel fills the diaphragm (at least 6 times). The diaphragm need not be completely filled.
Start the engine
WARNING! The cutting blade rotates when
!the engine is started. Make sure it can rotate freely.
•Grip the front handle with your left hand. Put your right foot on the lower section of the rear handle pressing the machine against the ground. Never wrap the starter cord around your hand
•Grip the starter handle, slowly pull out the cord with your right hand until you feel some resistance (the starter pawls grip), now quickly and powerfully pull the cord.
NOTICE! Do not pull the starter cord all the way out and do not let go of the starter handle when the cord is fully extended. This can damage the machine.
•With a cold engine: The machine stops when the engine fires becase the chokel control is pulled out.
Press the choke control and the decompression valve. Pull the starter handle until the engine starts.
18 – English
