How To Operate The Edger
The edger is designed to cut a small trench along sidewalks and driveways or to trim close to trees, flower beds, lampposts, etc. The main reason for edging is to enhance the overall appeal of the yard. A cleanly−edged yard gives a nice, overall finished look.
Always dress properly to protect against flying debris. Wear substantial shoes, long pants and close−fitting clothes that are not likely to get caught in the machinery. Also, make sure to wear safety glasses or goggles.
WARNING
Thrown debris can result in foreign objects being thrown into the eyes, which can cause severe eye damage.
•Always wear safety glasses or eye shields while you assemble, operate or do maintenance to the unit.
To reduce the risk of flying debris, inspect the area and remove any stones, sticks or other objects that could be thrown by the edger.
If the lawn has not been edged in a while, it may take several passes to obtain a nice, clean edge.
Because the front wheel and the right rear wheel are adjustable, the edger can be used on uneven surfaces, such as the curb shown in Figure 21.
NOTE: References to the right or left side of the edger are from the viewpoint of the operator’s position behind the unit.
1Before you start the engine, move the depth control lever (C) back until the blade (A) will not contact the ground.
2When edging along a concrete driveway or sidewalk, set the wheels on the concrete and position the blade along the left side of the driveway. To position the edger on a curb, see the
3Start the engine. See “How To Start The Engine”.
4Move the depth control lever forward to lower the blade. Do not try to edge too deep. It may take several passes to obtain a nice clean edge.
5Stand behind the edger and firmly hold the handle
(D). See Figure 20. As the blade begins to cut, slowly move forward.
6Proceed at a moderate pace until you are comfortable with the handling of the edger.
NOTE: To operate on a curb, see the
D |
C |
A |
B |
Figure 20: Operation Of Edger
Operation
GB
19
