ASSEMBLY
bolt and tighten securely.
•Snap steering wheel insert into center of steering wheel.
•Remove protective materials from tractor hood and grill.
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO ROLL OFF SKID.
| INSERT |
| 5/16 HEX BOLT |
| 5/16 LOCK WASHER |
| LARGE FLAT WASHER |
| STEERING |
| WHEEL |
STEERING BOOT | ADAPTER |
| |
TABS | TAB |
| |
| SLOTS |
EXTENSION SHAFT |
|
LOWER STEERING SHAFT |
|
| 03125 |
FIG. 2 |
INSTALL SEAT (See Figs. 2A and 2B)
• Remove bolt and flat washer securing seat to cardboard |
packing and set aside for assembly of seat to tractor. |
Remove the cardboard packing and discard. |
• Connect switch to seat. |
• Place seat on seat pan so all three (3) bottom pads |
are positioned over large slotted holes in pan. |
• Push down on seat to engage pads in slots and pull |
seat towards rear of tractor. |
• Raise seat and tighten bolt securely. |
• Remove tape and discard. |
• Lower seat into operating position and sit on seat. |
Press clutch/brake pedal all the way down. If operating |
SEAT |
SWITCH |
PAD |
SLOT |
SEAT |
PAN |
TAPE |
WIRING HARNESS |
FIG. 2A
SLOT |
| TAPE | |
PAD |
|
| |
FLAT |
|
| |
WASHER |
|
| |
SEAT PAN |
| ||
BOLT | TAB | ADJUSTMENT | |
HANDLE | |||
|
|
FIG. 2B
CHECK BATTERY (See Fig. 3)
•Lift seat pan to raised position and open battery box door.
•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at
SEAT PAN
LABEL
BATTERY
BOX DOOR
position is not comfortable, adjust seat. |
To adjust seat: Grasp adjustment handle and pull up, slide seat to desired position and release adjustment handle.
TERMINAL
TERMINAL
02021
FIG. 3
6