SERVICE AND ADJUSTMENTS

FRONT WHEEL TOE-IN/CAMBER

Your new tractor front wheel toe-in and camber is set at the factory and is normal. The front wheel toe-in and camber are not adjustable. If damage has occurred to affect the factory set front wheel toe-in or camber, contact a qualified service center.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 28)

Block up axle securely.

Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

Repair tire and reassemble.

On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

Replace washers and snap retaining ring securely in axle groove.

Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

RETAINING WASHERS

RING

AXLE

COVER

SQUARE KEY (REAR

WHEEL ONLY)

TO START ENGINE WITH A WEAK BATTERY (See Fig. 29)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the Maintenance section of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

BLACK cable first from chassis and then from the fully charged battery.

RED cable last from both batteries.

FIG. 28

WEAK OR DEAD BATTERY

FULLY CHARGED

BATTERY

FIG. 29

TO REPLACE HEADLIGHT BULB

Raise hood.

Pull bulb holder out of the hole in the backside of the grill.

Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

Check wiring. See electrical wiring diagram in the Repair Parts section.

22

Page 22
Image 22
Husqvarna LT1597 manual Front Wheel TOE-IN/CAMBER, To Remove Wheel for Repairs See Fig, To Replace Headlight Bulb

LT1597 specifications

The Husqvarna LT1597 is a robust riding mower designed for residential lawn care enthusiasts seeking efficiency and ease of use. With its powerful engine, advanced cutting technologies, and ergonomic design, the LT1597 is engineered to tackle a variety of lawn maintenance challenges while delivering exceptional performance.

At the heart of the LT1597 lies a durable engine that provides reliable power and performance. Featuring a Briggs & Stratton V-Twin engine, it ensures a smooth mowing experience with plenty of torque for tackling thick grass and uneven terrains. The engine's design promotes easy starting and minimal maintenance, allowing homeowners to focus more on lawn care and less on mowers.

One of the standout features of the LT1597 is its 97 cm (38-inch) cutting deck, which is optimized for achieving a precise cut over both flat and hilly landscapes. The deck comes equipped with a cutting system that utilizes three blades to produce consistent results while reducing clumping and ensuring a clean finish. Additionally, the cutting height can be easily adjusted, enabling users to customize their mowing height based on the season and lawn health.

Husqvarna integrates advanced technology into the LT1597 to enhance user experience. The mower features an ergonomic steering wheel and comfortable seating, providing a smooth ride even during extended mowing sessions. The dashboard includes easy-to-read indicators that keep track of crucial metrics such as fuel level and engine temperature, helping users stay informed during operation.

Another notable characteristic is the LT1597's maneuverability. With a tight turning radius, it allows users to navigate around flower beds, trees, and other obstacles with ease. The automatic transmission enhances the mowing experience further, providing a seamless transition between speeds and eliminating the need for manual gear shifting.

Safety is a top priority in the design of the LT1597. It includes features such as a safety switch that ensures the mower will stop if the operator leaves the seat, minimizing the risk of accidents. The robust build, combined with reliable components, ensures that the mower is built to last and withstand the demands of regular use.

In summary, the Husqvarna LT1597 stands out as a powerful, user-friendly riding mower, equipped with innovative features that make lawn care effortless. With its reliable engine, versatile cutting deck, ergonomic design, and commitment to safety, the LT1597 is a beneficial investment for those looking to maintain their lawns with professional results.