Husqvarna LTH18538 Assembly, iNSTALL SEAT See Figs. 3 and, TO INSTALL HOOD SCOOP See Fig

ASSEMBLY

iNSTALL SEAT (See Figs. 3 and 4) TO INSTALL HOOD SCOOP (See Fig. 5)

*Remove bolt and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor. Remove the cardboard packing and discard.

*Connect switch to seat.

Place seat on seat pan so all three (3) bottom pads are positioned over large slotted holes in pan.

/

/

SEAT /

SWITCH

PAD _

SLOT /

7_

t

I

TAPE

WIRING HARNESS

Fig. 3

Push down on seat to engage pads in slots and pull seat towards rear of tractor.

•Raise seat and tighten bolt securely.

•Remove tape and discard.

•	Lower	seat into operating	position and sit on seat.	®
	Press clutch/brake pedal all the way down. If operating
	position	is not comfortable,	adjust seat.

TO ADJUST SEAT (See Fig. 4)

•Grasp adjustment handle and pull up, slide seat to desired position and release adjustment handle.

SLOT TAPE

FLAT

WASHER

®

Fig. 5

SEAT PAN

ADJUSTMENT

BOLT TAB

HANDLE

Fig. 4

7