Changing the diamonds
Changing the diamonds
As different applications require different selections of
diamond tools, there will be many occasions when the grinding discs need to be changed.
Following is a guide for this procedure.
Preparation
1.Ensure STOP/RUN switch is in STOP position as unintentional starting of machine while changing
discs
can result in serious injury.
2.Have a set of gloves ready, as diamonds can get very
hot during dry grinding applications.
Changing
1.Set handle in upright position (illustrated right).
2.Pull back on handle to lift grinding head off the ground.
4.Lay machine back on the ground.
5.Put on gloves.
6.Remove grinding disc by slightly rotating disc and then
pull off (direction that the discs will need to be ro- tated
will depend on the direction the machine was last running).
7.Check to ensure all head locks/shear pins are tight.
8.Once new diamonds have been attached, reverse procedure to lower machine to ground.
9.As new diamonds may be a different height to set being previously used,
12- English
