Automower from 25
3. Installation
™
If the working area borders against a flat path or the
like that lies level with the lawn, it is possible to allow
the Automower to run a little over the path. The
boundary wire should then be laid 10 cm from the
edge of the path.
When the working area is divided by a flat slab path
that is level with the lawn, it is possible to allow the
Automower to run over the path. It can be an
advantage to lay the boundary wire under the slabs.
The boundary wire can also be laid in the joint
between the slabs.
Note! The Automower must never run over a gravel
path or similar material, which can damage the
blades.
If the working area borders against, for example,
pools of water the boundary wire should be
supplemented with a fence or the like. The height must
then be at least 15 cm. This will prevent the
Automower, under any circumstances, coming outside
of the working area.
When Automower searches for the charging station or
follows the loop according to the function Follow loop
(3-2) (see page 53), it runs along the side of the
boundary wire at a specific distance. The Corridor
width (3-2-3) function determines the distance from the
boundary wire that the mower shall run. It is
recommended to state as high a Corridor width value
as possible. A high Corridor width value reduces the
risk of tracks forming. For more information about
Corridor width (3-2-3), see page 56.
In exceptional cases Automower can be set to
straddle the boundary wire, that is to say, half the
mower inside the loop and the other half outside. The
boundary wire must then be kept at a distance of
about 40 cm from all the boundaries of the working
area and from the edges of a passage.
3012-383
10
cm
3012-534
3012-459