Numbers, Main switch | Husqvarna Robotic Lawn Mowe instruction

5.Control panel

5.4Numbers

9.Used in the menu structure to enter settings, for example, PIN code, time or exit direction.

Also used to specify a number series as a shortcut to the different menus. See more about number series in Number series on page 47.

5.5 Main switch

10.Set the main switch in the ON position to start the Automower.

Set the main switch in the OFF position when you are not using the mower or if you want to work on the blade disc.

When the main switch is set in the OFF position the motors on the mower cannot start.

When the main switch is turned ON for the first time, a start-up sequence begins which includes: selection of the language, time format, date format and four-digit PIN code, plus setting of the time and date, see page 34.

46 Automower from ™

3012-407

10

3012-408

Image 46

Husqvarna Robotic Lawn Mowe manual Numbers, Main switch

Contents

Operator’s manual Page Table of contents Table of contents Introduction and safety Introduction Symbols on Automower Symbols in the Operator’s Manual Xxxxxx xxxxx xxxx xxxx xxxxx Safety instructions Use Maintenance Transport Presentation Automower, what’s what? Numbers in the picture correspond to Capacity Function of AutomowerMowing technique Working method 3012-388 3012-700 3012-400 Movement pattern Search methodSearch method 1 Irregular Search method 3 Follow guide wire Search method 2 Follow loop More than one Automower in a garden One Automower in several gardens Installation Carry out the installation in the following steps Preparations Installation of the charging stationIdeal position of the charging station Low voltage cable must not be extended Installation and connecting the charging station Do not tread or walk on the charging station plate Installation of the boundary wire Charging the batteryBest position for the boundary wire 30 cm Boundaries for the working area 10 cm Boundaries within the working area Secondary areas Passages when mowing Passages when searching for the charging station Slopes Laying out the boundary wire Laying the boundary wire in towards the charging station Connecting the boundary wire Joining the boundary wire 3012-284 3012-264 Checking the installation Need of a guide wire Installation of the guide wireLinking the Automower to the charging station 3012-669 Placement and connection of the guide wire Maximum 3012-675 Charging a discharged battery Use Starting the Automower Using the timerStopping the Automower Restart within 20 seconds Switching off the AutomowerRestart Restart after more than 20 seconds Adjusting the cutting height Control panel Shortcuts Programs Select Main switch Numbers Browse between menus Menu functionsMain menu Number series Automower main menu Automower Commands Timer Day timer Timer overrideWeekend timer Garden Week timerMon Tue Wed Thu Fri Sat Sun Run all Exit angles Proportion first Follow loopFollow loop out Distance DirectionProportion Follow loop Corridor width Test When Test in 3-2-4 is used, the house iconTest OUT Normal Garden shapeOpen Complex Advanced Drive past wireCheck loop PIN code SettingsSecurity Time lock Stop protection Operation Settings lockSounds Keypad Language Sound Significance Time and date Garden example proposed installation and settings Garden shape Open Corridor width Guide wire Garden shape Normal Distance 40 m and Proportion 20 %. Area Proportion 40 % 3012-530 Maintenance Winter storage BatteryService Automower After winter storage CleaningUnderframe and blade disc Chassis Do not use running water when cleaningReplacing the blades Wheels 3012-260 Trouble shooting Fault messages Trouble shooting Automower runs at Symptom Cause Action Uneven mowingResults Wrong time Environmental Information Technical dataData Automower from Husqvarna EU declaration of conformity EU Declaration of Conformity only applies to Europe EU declaration of conformity Index Auto Main menu 43, 47 Start Automower Working area Boundaries Automower from Automower from Page 2005W48