OPERATION
MUFFLER | POWER CORD | AUGER | |
| CONTROL | ||
GASOLINE | PLUG | ||
LEVER | |||
FILLER CAP |
| ||
|
| ||
CHOKE | ELECTRIC |
| |
CONTROL | START |
| |
ON / OFF | BUTTON |
| |
|
| ||
SWITCH |
|
| |
|
| LIGHT |
PRIMER
SAFETY
IGNITION
KEY
FUEL
RECOIL STARTER HANDLE
CHUTE
DEFLECTOR
DISCHARGE CHUTE
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AUGERS | SKID PLATE |
| |
| FIG. 8 |
DISCHARGE CHUTE CONTROL LEVER
DRIVE SPEED
CONTROL LEVER
DEFLECTOR
REMOTE
CONTROL
LEVER
TRACTION
DRIVE
CONTROL
LEVER
HANDLE KNOB
MUFFLER
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting engine.
Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.
Choke Control - used for starting a cold engine. ON / OFF switch - used to STOP the engine.
Fuel shut off valve - used for shutting off the fuel flow to the engine.
Drive speed control lever - used to select forward or reverse motion and speed of snow thrower.
Traction drive control lever - used to engage power- propelled forward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw snow).
Discharge chute control lever - used to change the direc- tion the snow is thrown.
Deflector remote control lever - used to change the distance the snow is thrown.
Skid plate - used to adjust height of scraper bar from the ground.
8