PRE OPERATION CHECKLIST
Before leaving our factory, every machine is thoroughly tested. Follow our instructions strictly and your machine will give you long service in normal operating conditions.
Before starting up the machine, make sure you read this entire Operation’s Manual and are fa-
miliar | with the operation of the machine. |
WITH MACHINE COLD AND SETTING LEVEL:
1.Gasoline Models: Check engine oil. Fill to the full mark on dip stick with 10W30 oil, class MS, SD, SE or better.
2.Electric Models: Verify all electrical connections are intact.
1 - 2 HOUR OPERATION CHECK LIST:
ALWAYS place the machine on a level surface with the engine/motor “OFF", the ignition switch set in the “OFF” position and disconnected from the power source before performing any maintenance. Let the machine cool down!!
1.Check the engine air cleaner hose clamps. Tighten as required.
2.Tension the blade drive
SCHEDULED MAINTENANCE QUICK REFERENCE:
Before performing any maintenance, ALWAYS place the machine on a level surface with the engine/motor “OFF” and the ignition switch set in the “OFF” position.
SERVICE DAILY:
1.Check engine oil level.
2.Check blade guard for damage.
3. Check hoses and clamps for damage . or looseness. Tighten or replace as necessary.
4.Check air cleaner. Clean or replace as required.
5.Clean the reservoir pan frequently.
6.At the end of each day, flush clean water through the water pump and hoses
SERVICE EVERY 50 HOURS:
1.Replace engine oil and filter.
2.Clean engine air fins.
3.Check blade drive
4.Clean engine fuel bowl.
15
