MAINTENANCE
Ignition System
The engine is equipped with an electronic ignition system. Only the spark plugs require maintenance.
For recommended spark plugs, see Technical Data.
1.Remove the ignition cable boot and clean around the spark plug.
2.Remove the spark plugs with a spark plug socket wrench.
3.Check the spark plugs. Replace the spark plug if the electrodes are burned or if the insulation is cracked or damaged. Clean the spark plug with a steel brush if it is to be reused.
4.Measure the electrode gap with a gapping tool. The gap should be 0.030” (0.75 mm). Adjust as necessary by bending the side electrode.
5.Reinsert the spark plugs, turning by hand to avoid damaging the threads.
6.After the spark plug is seated, tighten it using a spark plug wrench so that the washer is compressed. Used spark plugs should be turned 1/8 of a turn from the seated position. New spark plugs should be turned 1/4 of a turn from the seated position.
7.Connect the ignition cable.
IMPORTANT INFORMATION
Fitting the wrong spark plug type can damage the engine.
Inadequately tightened spark plugs can cause overheating and damage the engine. Tightening the spark plugs too hard can damage the threads in the cylinder head.
Measure the electrode gap
