Husqvarna YTH170 Eng Switching off the engine, DAbstellen des Motors, FArrêt du moteur

Models: YTH170

1 72
Download 72 pages 44.17 Kb
Page 47
Image 47
Eng Switching off the engine

5

Eng Use the left side of the machine to cut close to trees, bushes and paths, etc. The blade cuts about 15 mm inside the edge

of the cover.

DDie linke Seite der Maschine benutzen, um in der Nähe von Bäumen, Gebüsch, Gängen usw. zu mähen. Die Mähklinge mäht ca. 15 mm innerhalb der Haubenkante.

FUtiliser le côté gauche de la machine pout tondre à proximité des arbres, des arbustes, des allées, etc. Le couteau coupe à environ 15 mm à l’intérieur du bord du capot.

Esp Utilice el lado izquierdo de la máquina para poder cortar cerca de árboles, arbustos, senderos, etc. La cuchilla corta a unos 15 mm por dentro del borde de la cubierta.

IUsare il lato sinistro della macchina per tagliare in prossimità di alberi, cespugli, vialetti ecc. Le lame tagliano circa 15 mm all’interno del coprilame.

NL Gebruik de linker kant van de machine om dicht bij bomen, heesters en dergelijke te kunnen maaien. Het mes maait ca. 15 mm van de kant van de kap.

Eng Switching off the engine

Move the gas control to “DAbstellen des Motors”. Disconnect the cutting unit by moving the connect/discon-nect lever downwards. Lift up the cutting unit and turn the ignition key to “OFF” position. Allow the engine to idle for 1-2 minutes to cool down before switching off after a hard work.

DAbstellen des Motors

Gashebel nach unten auf “FArrêt du moteur” führen. Mähaggregat durch Abwärtsführen des Aggregatschalthebels auskuppeln. Mähaggregat anheben und den Zündschlüssel auf “OFF” drehen. Den Motor 1-2 Minuten im Leerlauf arbeiten lassen, damit dieser nach längerem Mähbetrieb abkühlen kann.

FArrêt du moteur

Amener la comande de gaz en position (ralenti), vers le bas “Esp Parada del motor”. Débrayer les lames, Relever le carter de coupe, Laisser le moteur tourner au ralenti pendant 1 à 2 minutes pour qu'il refroidisse avant de l'arrêter aprés un travail pénible, puis tourner la clef de contact en position (off).

Esp Parada del motor

Lleve el acelerador hacia abajo hasta la posición “Manual background”. Desacople el equipo de corte llevando hacia abajo la palanca de acoplamiento/desacoplamiento. Levante el equipo de corte y ponga la llave de encendido en la posición “OFF” (apagado). Deje funcionar el motor en ralentí 1-2 minutos para que se enfríe antes de pararlo después de un tiempo de uso intenso.

47

Page 47
Image 47
Husqvarna YTH170 Eng Switching off the engine, DAbstellen des Motors, FArrêt du moteur, Esp Parada del motor