hussman P/N IGUP-AB-0904 Electrical Precautions, Replacing Fluorescent Lamps, Motor

IGUP-AB-0904

Maintenance

ELECTRICAL PRECAUTIONS

BEFORE SERVICING – Always disconnect electrical power at the main disconnect when servicing or replacing any electrical component

This includes (but not limited to) Fans, Heaters,

Thermostats, and Lights.

REPLACING FLUORESCENT LAMPS

Fluorescent lamps are furnished with a shatterproof pro- tective coating. The same type of lamp with protective coating must be used if replaced.

This lamp has been treated to resist breakage and must be replaced with a similarly treated lamp in order to maintain

compliance with NSF Standards.	NSF CODE 4.28.1
Contact HUSSMANN Chino for replacement
1-800-395-9229	x 2131

T-5 BULBS

Please note:T-5 lights must be turned off and on after bulb replacement.

EVAPORATOR FANS

The evaporator fans are located at the center front of these merchandisers directly beneath the display pans. Should fans or blades need servicing, always replace fan blades with the raised embossed side of the blade TOWARD THE

MOTOR.

COPPER COILS

The copper coils used in Hussmann merchandisers may be repaired in the field. Materials are available from local refrigeration wholesalers.

Hussmann recommends using #15 Sil-Fos for repairs.

TIPS & TROUBLESHOOTING

Before calling for service, check the following:

1.Check electrical power supply to the equipment for connection.

2.Check fixture loading. Overstocking case will affect its proper operation.

3.If frost is collecting on fixture and/or product, check that Humidity Control is working properly, and that no outside doors or windows are open—allowing moisture to enter store.

FOR PROMPT SERVICE

When contacting the factory,

be sure to have the Case Model and Serial Number handy. This information is on a plate located on the case itself.

Electrical and Refrigeration Specifications

MODEL NUMBER		TEMPERATURE			DISCHG.			FAN SIZE	DEFROST		115 V. ELECTRICAL CIRCUITS
	BTU		AVG		AIR	T-STAT/	TYPE	&	FREQ.
CASE LENGTH	REQ’D	EVAP	PROD	DISC	VELOC	CUT IN	OF	NUMBER	&	E E FANS	STD.			Humidity
	PER FT.	TMP	TMP	TMP	@FPM	SETTINGS	COIL	OF MOTORS	DURATION	(OPTIONAL)	FANS	WARMERS	LIGHTS	System
AB
Blower Coil													Humidity System
5’	990	25	34	26	200	35	Forced	4" C-frame	36 min.	-	2.5	-	.58	3.6
							Air	( 3 )	(4)
6'	990	25	34	26	200	35	Forced	4" C-frame	36 min.	-	3.5	-	.58	3.6
							Air	( 5 )	(4)
Gravity Coil													HumiditySystem (opt.)
5’ & 6'	360	25	35	25	-	35	Gravity	-	90	-	-	-	.58	3.6
									(1)

16