Hustler Turf Z XR7 manual Deck Lift

4.Set cutting height at 3-1/2" in the height indicator by placing the height adjusting stop in the 3-1/2" hole, and turning the height stop so that the pin side is against the stop handle FIG. 32

5.Clamp the height adjusting stop against the stop handle FIG. 32. This will assure that the height will not move during the setting process. Otherwise, spring pressure from the deck lift springs will tend to pull the stop away from the handle.

STOP HANDLE

HEIGHT

ADJUSTING

STOP

FIG. 32

6.Loosen all nuts on the deck lift threaded rods, and the hardware on the adjuster (on the right front), until all the deck lift chains are loose, and the deck is sitting tightly on all four blocks FIG. 33, FIG. 34, FIG. 35.

	DECK LIFT
	THREADED ROD
NUT	NUT
	CHAINS

NUT	DECK LIFT
	THREADED ROD
CHAINS	NUT

FIG. 33	FIG. 34
ADJUSTER	5/16" BOLT
	JAM NUT
HARDWARE

FIG. 35

10-31 106567 4/07