Hustler Turf Z XR7 manual Torque values, Introduction

INTRODUCTION

Regular maintenance is the best prevention for costly downtime or expensive, premature repair. The following pages contain suggested maintenance information and schedules which the operator should follow on a routine basis.

Remain alert for unusual noises, they could be signaling a problem. Visually inspect the machine for any abnormal wear or damage. A good time to detect potential problems is while performing scheduled maintenance service. Correcting the problem as quickly as possible is the best insurance.

Clear away heavy build-up of grease, oil and dirt, especially in the engine and hydraulic reservoir areas; minute dust particles are abrasive to close-tolerance engine and hydraulic assemblies.

Daily inspect mower for grass clippings and wire and string tangles. The underside of the mower deck will collect a build-up of grass clippings and dirt, especially when grass is wet or has high moisture content. This build-up will harden, restricting blade and air movement and will probably show a poorer quality of cutting. Therefore it should be removed routinely.

To do this it will be necessary to raise and block the deck in the full up position, using jack stands or blocks, and scrape the build-up from underneath.

Some repairs require the assistance of a trained service mechanic and should not be attempted by unskilled personnel. Consult your Hustler service center when assistance is needed.

Torque values

WARNING: Particular attention must be given to tightening nuts and blade spindle bolts. Failure to correctly torque these or blade, which can cause serious damage or personal injury.

Torque values are given below:

the drive wheel lug nuts, wheel motor items may result in the loss of a wheel

	Ft-lbs.	Nm
Wheel (lug) nuts	65-75	88.14-101.7
Wheel motor nut	290-310	393.2-420.4
Blade spindle bolt top	65-75	88.14-101.7
Blade spindle bolt bottom	118	160.01

It is recommended that these be checked after the first 2 hours of operation initially, every 50 hours, and following removal for repair or replacement.

For all other torques refer to the various tractor parts manuals for standard torque charts. NOTE: For engine torque values, see engine owner’s manual.

10-11 106567 4/07