I-Data 5250 ALLY manual Configuration Defaults, Agile!=Por, Agile!=Save

Page 2-4 AGILE 5250 ALLY User’s Guide and Reference

Configuration Defaults

The 5250 ALLY is shipped from the factory with a given set of parameters called “defaults.” The default configuration will allow most operators to use the 5250 ALLY after making few, if any, configuration changes. These factory defaults, including the default programmable function strings and translation tables, can be restored at any time by sending the trigger followed directly by the terminator, as shown:

!AGILE!;

To reset an individual configuration parameter to its default setting, enter the trigger, the option number and the terminator. The following example sets the twinax host Xerox PFS suppression value to its default setting (note that this is one of the four-digit options):

!AGILE!0601;

Note: Xerox special options are described in Appendix A — Interfacing Xerox Printers.

Power-On Reset

If the user has made configuration changes and would like the unit to return to its previous configuration, the user can cancel any unsaved changes and return the unit to its former power-on state with the following command:

!AGILE!=POR;

Save Configuration

After making any configuration changes, unless the changes are to be temporary, the user must save the configuration to the 5250 ALLY flash memory with the following command:

!AGILE!=SAVE;