If you use a print queuing system other than a PC print server and
you experience what appears to be an EOD command problem, you
may need to use another procedure, such as a print utility, an initial-
ization sequence, or a header page to add an EOD command. See
your print queuing system documentation, your network administra-
tor, or your QMS vendor for more information.
Use the following procedure to set the end job mode from the printer’s
control panel for printers connected via the serial or parallel interface
to a stand-alone PC, a PC print server, or some other type of print
queuing system:
Wait for the printer to go idle, and then press the control panel keys in
the order shown in the following instructions to access the End Job
Mode option. The printer responds by displaying a status message in
the message window.
Key Purpose Message Window
Online/Offl
ine Turns off the Online/Offline indicator and
readies the printer for configuration. IDLE
Menu Accesses the configuration menu. CONFIGURATION
OPERATOR CONTROL
Next Advances to the Operator
Control/Administration menu. CONFIGURATION
ADMINISTRATION
Select Accesses the Administration menu ADMINISTRATIO N
COMMUNICATIONS
Next Adv ances to the Communications/Parallel
(or Serial) menu. COMMUNICATIONS
PARALLEL (
or
SERIAL)