Replacing a memory module
Attention:
Do not remove the computer cover or attempt any repair before reading the “Important safety information” in the Quick Reference that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Quick Reference or HMM, go to http://www.ibm.com/pc/support.
1.Remove the computer cover. See “Removing the computer cover” on page 5. Note: For this procedure, it helps to lay the computer on its side.
2.Locate the memory module connectors. See “Locating components” on page 1.
3.Open the retaining clips, and lift the memory module out of its connector.
4.Ensure that the notch on the new memory module 1aligns correctly with the connector key 2 on the system board. Push the memory module straight down into the connector until the retaining clips close.
5.Go to “Completing the installation” on page 33.
