IBM 8840 manual Add the following five lines between the two title= sections

Modified /etc/lilo.conf contents

prompt timeout=50 default=linux-Monitor boot=/dev/hda #map=/boot/map install=/boot/boot.b #message=/boot/message linear

#This will allow you to only Monitor the OS boot via SOL image=/boot/vmlinuz-2.4.9-e.12smp

label=linux-Monitor initrd=/boot/initrd-2.4.9-e.12smp.img read-only

root=/dev/hda6 append="console=ttyS0,19200n8 console=tty1"

#This will allow you to Interact with the OS boot via SOL image=/boot/vmlinuz-2.4.9-e.12smp

label=linux-Interact initrd=/boot/initrd-2.4.9-e.12smp.img read-only

root=/dev/hda6

append="console=tty1 console=ttyS0,19200n8 " image=/boot/vmlinuz-2.4.9-e.12

label=linux-up initrd=/boot/initrd-2.4.9-e.12.img read-only

root=/dev/hda6

2. Run the lilo command to store and activate the LILO configuration.

When the Linux operating system starts, a LILO boot: prompt is displayed instead of the graphical user interface. Press Tab at this prompt to install all of the boot options that are listed. To load the operating system in interactive mode, type linux-Interactand then press Enter.

GRUB configuration: If you are using GRUB, complete the following steps to modify the /boot/grub/grub.conf file:

1.Comment out the splashimage= line by adding a # at the beginning of this line.

2.Add the following line before the first title= line:

#This will allow you to only Monitor the OS boot via SOL

3.Append the following text to the first title= line:

SOL Monitor

4.Append the following text to the kernel/ line of the first title= section: console=ttyS0,19200 console=tty1

5.Add the following five lines between the two title= sections:

#This will allow you to Interact with the OS boot via SOL

title Red Hat Linux (2.4.9-e.12smp) SOL Interactive

root (hd0,0)

Chapter 2. Configuring the server 27