IBM ARTIC186 manual Setting the ISA Connector Type, Setting the Base I/O Address

Setting the ISA Connector Type:	Switch 9 (ED) specifies the type of system connector used
with the adapter: the double	connector (16-bit ISA connector) or the single connector (
connector).

Switch 9 (ED)	Edge-Connector
On	Adapter	is	in	a
	double-connector			slot
Off	Adapter	is	in	a
	single-connector			slot

Figure 2-3. ISA Connector Type Switch

Setting the Base I/O Address:	Switches 5 through 8 (C1, C2, C4, and C8) select the base I/O
address.

If you install more than one IBM ARTIC adapter in ISA slots, set each adapter to a address to prevent resource conflicts.

Note: Adapters installed in PCI slots are configured automatically and do not affect the adapters installed in ISA slots.

2-6IBM ARTIC186 8-Port Adapter GTO