Downloading the Diagnostics and Operating-System Support
Programs
Download the adapter diagnostic and
For telephone
For
| Running | Diagnostics | to Verify | Installation | |||
Before | continuing | with | “Connecting the Optional Adapter Cable,” run the diagnostic test | ||||
See | Chapter 5, | “Problem | Determination Procedures” for testing an | ||||
| Connecting | the | Optional | Adapter | Cable |
Use the following steps to connect your adapter cable.
Note: The optional adapter cables are described on page
Lightning protection. Do not connect or handle the cable during a lightning storm.
1. Align | the | connector of | the adapter cable with the adapter connector at the rea |
can | fit | properly only | one way. |
2. Firmly press the adapter cable onto the adapter connector.
3. Insert and tighten the screw at each side of the connector on the cable.
4. Connect your device to the other end of the adapter cable.
The
Installing | the | Microcode and | Support | Programs |
For instructions | on installing | the | required software, as listed under “Software/Microcode | |
the documentation supplied with the applicable software. | ||||
Setting | Up the | Configuration | Files |
|
See Appendix A, “Special Configuration Information for DOS and OS/2” for important setup creating an ICAPARM.PRM file and changing the CONFIG.SYS file. The changes are necessary correct operation of your
Installation and