FRU Removals and Replacements
This section contains information about removals and
replacements.
vDo not damage any parts. Only certified and trained
personnel should service the computer.
vThe arrows in this section show the direction of
movement to remove a FRU, or to turn a screw to
release the FRU. The arrows are marked in numeric
order,in square callouts, to show the correct sequence
of removal.
vWhen other FRUs must be removed before the failing
FRU is removed, they are listed at the top of the page.
vToreplace a FRU, reverse the removal procedure and
follow any notes that pertain to replacement.
vWhen replacing a FRU, use the correct screw size, as
shown in the procedures.
Safety Notice 1::
Before the computer is powered on after FRU
replacement, make sure all screws, springs, or other small
parts, are in place and are not left loose inside the
computer.Verify this by shaking the computer and listening
for rattling sounds. Metallic parts or metal flakes can cause
an electrical short circuit.
Safety Notice 4::
The battery can cause a fire, explosion, or severe burn. Do
not recharge it, remove its polarized connector,
disassemble it, heat it above 100°C (212°F), incinerate it,
or expose its cell contents to water.Dispose of the battery
as required by local ordinances or regulations. Use only
the battery in the appropriate parts listing. Use of an
incorrect battery can result in ignition or explosion of the
battery.
Safety Notice 8::
Before removing any FRU, power-off the computer,unplug
all power cords from electrical outlets, remove the battery
ASM, and then disconnect any interconnecting cables.
An electrostatic discharge (ESD) strap (P/N 6405959) must
be used to establish personal grounding.
FRU Service Procedures
Review the following procedures before replacing any
FRU.
28 ThinkPad s30, s31