Note: The pull-down menu differs depending on the
model.
4. Run the applicable function test.
5. Follow the instructions on the screen. If there is a
problem, PC-Doctor shows some messages.
6. Reseat the cable or connector of the detected FRU
and run the test again.
If the error recurs, replace the FRU that caused the
error.
Note: With some FRUs, especially the system board,
the problem may be caused by peripheral
FRUs. Verifythat each peripheral FRU, such as
the flexible cable, has no problem by doing the
following:
a. Replace each peripheral FRU one at a time,
and run the test again.
b. If the peripheral FRUs have no problem,
replace the main FRU itself.
7. Toexit the test, select Quit – Exit Diag.
Tocancel the test, press Esc.
The following table lists the options on the test menu.
Diagnostics InteractiveTests
vRunNormal Test
vRunQuick Test
vCPU/Coprocessor
vSystemboard
vVideoAdapter
vFixedDisks
vDisketteDrives
vOtherDevices
vMemoryTest –Full
vMemoryTest –Quick
vKeyboard
vVideo
vInternalSpeaker
vMouse
vJoystickTest
vDisketteTest
vSystemLoad
vStereoSpeaker
Note: InKeyboard test within Interactive Tests, the Fn key is
scannedonly once. Each key should be pressed for at least 2
seconds;otherwise, it cannot be sensed.
Note: (s30 only) The testing of 802.11brequires an
Access Point properly prepared prior to conducting
the test. When testing 802.11bwith PC-Doctor
DOS, please confirm the following points:
1. An OBI’sAccess Point is located about 3 meters
from the system.
2. The encryption is disabled on theAccess Point.
ThinkPad s30, s31 11