Figure 3. Location of Card Assembly 2884 in 820 Unit |
| |
__ 7. Remove the 2884 card assembly | or | from the system unit by doing |
the following: |
|
|
__ a. Unlatch the two blue latches on the 2884 until the card assembly slightly “pops” out.
__ b. Pull on both latches at the same time to remove the card assembly from the system unit.
__ c. Turn the card assembly over and lay it on the static protective bag provided.
Adding memory to the card assembly
__ 1. Before you remove the blank filler cards and install the memory into the card assembly, read the following:
vFigure 4 on page 6 shows memory card locations on the main storage card assembly.
vFill positions C and D before installing memory cards in positions E, F, G, and H.
vInstall memory in sets of four. For example, you cannot fill only positions E and G and later fill positions F and H. You must install all four memory cards at one time.
vPairs of memory cards must be either 128MB, 256MB, or 512MB. Pairs installed in E and G must match pairs installed in F and H.
vGo to step 2 on page 6.
Installation Instructions | 5 |
