IBM ZMAXdp Installing a DIMM, SFF Workstation, Installing Memory Modules, User’s Manual

SFF Workstation Installation Guide

Installing a DIMM

Make sure to unplug the power supply before adding or removing DIMMs or other system components. Failure to do so may cause severe damage to both the motherboard and the components.

Installing Memory Modules

„ Unlock a DIMM socket by pressing the retaining clips outward.

„ Align the ”notch” on the memory module to the “break” on the socket.

„ Firmly insert the module into the socket until the retaining clips snap back into place and the module is properly seated.

„ Make sure the memory module is locked on the socket with both retaining clips.

To avoid damaging a memory module slot, move the end latches slightly outward to relieve pressure.

The BIOS recognizes the installed memory and configures the CMOS Setup Utility automatically.

A DDR DIMM is keyed with a notch so that it fits in only one direction. DO NOT force a DIMM into a socket to avoid damaging the DIMM.

User’s Manual 27