5.Place the tape drive so that the front faces you, then tilt it on its left side (see Figure 32).
6.At the bottom of the drive, locate the access hole (1 in Figure 32).
Attention: In the following steps, do not allow drive components to touch the head 2. Damage may result to the head.
7.Insert a
Figure 32. Rewinding the leader pin into the tape cartridge
8.With clean
Note: If the leader pin is not connected to the tape, set the pin aside. After you remove the cartridge, reattach the pin (see “Repositioning or Reattaching a Leader Pin” on page 55).
90IBM TotalStorage LTO Ultrium 2 Tape Drive