CD10022 | CD20030 |
CD10522 | CD20530 |
Key Kit Installation |
|
This kit has been designed for use with the CD10022, CD10522, CD20030 and CD20530 ice dis- penser. When this kit is installed, ice cannot be dis- pensed unless a specific type of key is inserted into the lock cylinder. The kit contains a universal mount- ing fitting for lock cylinders and a switching mechanism.
NOTE: The user must supply their own lock cylinders.
Electrical shock hazard. Electrical shock can cause personal injury. Disconnect power before begining to service components.
1.Make sure all electrical power is disconnected to the dispenser before attempting to install this kit.
2.Remove the front plastic molded front panel, then remove the cover plate which is located below the push button. This cover plate is held in place with
4locknuts which are to be removed from the inside of the cabinet.
3.Obtain a lock cylinder common to those used by the establishment. Insert the cylinder in the brass fitting supplied in the kit. Mark the amount of the cylinder that extends beyond the brass fitting. Re- move the cylinder from the brass fitting and cut off the cylinder at the mark.
4.Insert the brass fitting into the hole in the cover plate provided in the kit. Place switch mounting bracket behind cover plate and over the brass fitting.
Next, add the plastic washer over the brass fitting and behind the switch mounting bracket. Using the locknut provided in the kit fasten the fitting in place with the flats in a vertical position. Place thecylinder in the fitting and secure it with the key slot parallel to the flats on the fitting collar using the set screw provided.
5.With a key in place, adjust the snap action of the micro switch so that it actuates when the key is inserted.
Now disconnect wire #8 and #9 from the normally open (NO) terminal of the dispense switch (S2) and reconnect it to the normally open (NO) terminal of the room key microswitch.
Connect wire #6 supplied in the kit to the normally open (NO) terminal of the dispense switch (S2) and to the common (C) of the room key micro- switch.
Check all of the wires and terminals to make sure the unit is wired correctly and all terminal connections are tight and secure.
7
