Icom iF22SR instruction manual Using the Dtcs Code

3 BASIC OPERATION

DUSING THE DTCS CODE

This transceiver is equipped with 83 DTCS codes. DTCS operation provides communication with silent standby since you will only re- ceive calls from group members using the same DTCS number.

You can assign different numbers to CH 1 to CH 15 independently.

qWhile pushing and holding [PTT], [S-Ring/C-Ring] and [MONI], turn [VOL] to turn the power ON.

wSelect the desired CH 1 to CH 15 that you want to assign the DTCS code to.

ePush and hold [MONI] until a beep (Pi) is emitted.

rPush [PTT] the necessary number of times to choose the 100 digit of the desired code number.

tPush [S-Ring/C-Ring].

•Confirmation beep is emitted. (See p. 15)

yPush [PTT] the necessary number of times to choose the 10 digit

of the desired code number.

uPush [S-Ring/C-Ring].

•Confirmation beep is emitted. (See p. 15)

iPush [PTT] the necessary number of times to choose the 1 digit

of the desired code number.

oPush [S-Ring/C-Ring].

•Confirmation beep is emitted. (See p. 15)

!0Push [PTT] once more, if you want to use Inverse mode. !1Push [S-Ring/C-Ring] to complete the setting.

•Confirmation beep is emitted. (See p. 15)

!2Turn the power OFF, and then ON again.

17