Industrial Ethernet Layer 2 Managed Switch – Web Management Manual
Email Setting
User can select “Disable Alarm Mail” to stop the em ail alarm sending (factory default). If email alarm is enabled, there are two methods of email report for you select.
The first one is: warning mail is sent immediately when events occur.
The second is: user can specify the interval time between 1 to 99 hour(s), and system will sending the system report by email every the specified hour(s).
Before active email sending, you have to finish following settings.
Mail Server IP | IP address of mail server |
Sender | Specify the email address of sender. |
Receiver. | Specify the email address that you wish to notify. |
After finishing and activating above setting, the “Send Test Mail” button will show up. You can click the button to check if the settings are correct.
NOTE!!
Please be sure the MASK and GATEWAY are properly configured. Otherwise, it may cause the email sending fault.
April 29, 2008 | 16 |
