Then, place them at 11 mm from the side edges and at 10 mm from the rear edge, as shown in Fig. 6, taking care that the seals meet without overlapping.
2.Place the hob in the cut out, taking care that it is centred.
3.Fix the hob with the relevant fixing clamps, supplied with the injectors kit (see diagram). When the screws have been tightened, the excess seal can be removed.
The edge of the hob forms a double seal which prevents the ingress of liquids.
Fig. 6
| a |
a) seal | Fig.7 |
Possibilities for insertion
Kitchen unit with door
Proper arrangements must be taken in designing the forniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in Fig. 8. The panel fitted under the hob should be easily removable to allow an easy access if a technical assistance intervention is needed.
Fig. 8
a) Removable panel
b) Space for connections
18
