INSTALLATION
Pre Installation
1.It is mandatory to have a 16 amp.
rAvoid the machine coming in contact with floor cleaning
chemicals.*
rDo not wash or spray water over the switch or control panel. rDo not allow children/pets to play with the machine. rDo not wash shoes or utensils in the machine. rKeep machine away from fire or heat.
2. Fixed plumbing is recommended | ||
for the machine. | The water inlet | |
of the machine has a collar | ||
with3/4”parallel | internal | threads. |
The water supply point with an | ||
external 3/4” | parallel | thread |
should be available within1 meter | ||
of the machine’s location. |
| |
WATER |
| MACHINE |
SUPPLY | REDUCER | WATER |
|
| INLET |
STOP |
|
|
LOCK |
|
|
1/2 | 3/4 |
|
rIFB will not be responsible if the user uses accessories not manufactured or recommended by IFB.
rTake care when draining hot washing solution.
orDo always become very hot during washing at higher temperatures. Keep children away from the appliance while it is in use.
3. Two options on the water inlet and |
drain pipe connection are shown. |
In case these possibilities do not |
exist for the drain pipe, please |
arrange an additional length of |
pipe. |
DRAIN |
PIPE |
WATER INLET |
WATER INLET |
DRAIN |
PIPE |
*Exposure can lead to rusting/corrosion.
SPECIAL NOTE
4.Please inform our service centre for installation and demonstration of the machine once the points mentioned above have been completed.
Unpacking
1. Remove Carton.
2. Remove top packing cover.
3. Remove side packing and plastic jacket.
4. Remove packing from the bottom of the
motor
5.Place the machine at the site at which it is to be 
Installed, and put the rat mesh.
8
ONLY USE A DETERGENT RECOMMENDED FOR FRONT LOADING WASHING MACHINES. A DETERGENT WHICH FOAMS EXCESSIVELY CAN DAMAGE THE MOTOR AND DETERIORATE THE RINSE QUALITY.
INSTALL MACHINE IN A ROOM WITH ADEQUATE VENTILATION. AVOID A ROOM WITH NO WINDOWS. THE BACK OF THE MACHINE SHOULD BE AT LEAST 4 INCHES (100 mm )AWAY
FROM THE WALL.
IF YOU USE A COVER OR TABLE CLOTH ON THE TOP LID, MAKE SURE THAT THE VENTILATION SLOTS AT THE BACK ARE NOT COVERED OR BLOCKED. THIS PRECAUTION WILL PROLONG THE LIFE OF ELECTRICAL AND RUBBER COMPONENTS.
37
