17
Bed Height :
he infeed conveyor is equipped with four (4)
adjustable legs that are located at the corners of
the frame. The legs can be adjusted to obtain
different conveyor bed heights from 585mm [23 inch]
minimum to 715mm [28.1 inch] maximum. Refer
to Figure 7-3 and the Specifi cation Section.
1. Block up the conveyor frame to allow
adequate leg adjustment.
2. Loosen, but do not remove, two
M8 x 16mm socket screws in one leg. Adjust
the leg length for the desired bed height.
Retighten the two (2) screws to secure the
leg. Adjust all four (4) legs equally.
7.1 Operating Conditions
The machine should operate in a dry and relatively
clean environment at 5° to 50°C. with clean dry
boxes-relative humidity between 0% and 80%
7.2 Space Requirements for Machine Operation
and Maintenance Work
Minimum distance from wall (Figure 7-1):
A = 1.0m. (39.4 inches)
B = 0.7m. (27.6 inches)
Minimum height = 2.7m. (106.3 inches)
7.3 Machine Positioning / Bed Height
7-INSTALLATION AND OPERATION
Figure 7-1
M8 x 16
Socket Head
Screws
Adjustable
Leg
• To reduce the risk associated with
mechanical and electrical hazards:
− Read, understand, and follow all safety and operating instructions before operating or
servicing the Infeed Conveyor/Case Sealer.
WARNING
• To reduce the risk associated with
muscle strain:
− Use the appropriate rigging and material handling equipment when lifting or
repositioning this equipment.
− Use proper body mechanics when removing or installing taping heads that are
moderately heavy or may be considered
awkward to lift.
WARNING
Figure 7-3
Figure 7-2
B
A
2011 June
a80f-if-NA