Water Inlet
1.Connect inlet hose to water tap/line.
2.Do not connect machine to a hot water supply.
WATER INLET |
DRAIN |
PIPE |
MACHINE DOES NOT START.
qCheck position of programme selector knob
qCheck water supply
qPorthole door not closed properly
qIndicator lamp not glowing
Water Outlet
1.A drain pump is provided in the machine to pump out used water.
2.The end of the outlet should be placed near a drain. If necessary, it can be placed over the edge of a sink at a maximum height of 1 mt. from the floor level.
3.Allow free flow of water from the outlet pipe.
DRAIN |
PIPE |
WATER INLET |
MACHINE DOES NOT SPIN / CLOTHES REMAIN WET.
qCheck if the No Spin button is pressed.
qwater not drained out completely
qUnblanced load ( Divide the load in two halfs and spin each load using exclusive spin program with desired spin speed or add smaller articles of laundry to balance the load & repeat the spin cycle.)
qExcessive detergent / Foam qLoad is too small.
Electrical Connection
rCheck that the electrical line take the required
load.
rConnect to a 230V, 50Hz single phase AC supply. The appliance must be positioned so that the plug is accessible.
rMachine must be earthed properly before operation. This can be done by using a 3 - pin plug and a properly earthed operated socket of 16 Ampere rating.
rIf the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. It should not be stretched when connected to the main socket.
16 AMPS
X
X
MOTOR NOISE
It is normal for noises to be heard while motor is running. However wash load, belt tension and motor mounting bolt should be checked for specified limits.
PUMP NOISE
It is normal for noises to be heard from the pump during the start- up and final stage of draining.
10 | 35 |
