Iiyama E1706S user manual Fitting and Removal of Base ProLite B1706S, Installation

FITTING AND REMOVAL OF BASE : ProLite B1706S

The monitor is supplied complete with a stand-base. If you prefer to wall mount the monitor, please follow the instructions below to remove the stand-base. Be sure to include the stand with the monitor if it is necessary to return the unit.

CAUTION Put the monitor on a stable surface. The monitor may cause injury or damage if it falls or is dropped.

Do not give a strong impact to the monitor. It may cause damage.

Unplug the monitor before removal or installation to avoid electric shock or damage.

<Installation>

A Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched. Lay the monitor flat on a table with front face down.

BInstall the Stand-Base to the Monitor.

CFix the Monitor with the Stand by the screw firmly, and the knob of the screw push down.

Stand-Base

Push-down knob

Screw for

Stand-Base fixing

<Remove>

A Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched. Lay the monitor flat on a table with front face down.

BPull up the knob of the screws, and remove the screw and the Stand-Base.

<Stopper pin>

Please stand the monitor and then remove the stopper pin on the back of the stand slowly while pushing top face of the stand before you install the monitor. Careful attention is required as the monitor is sprung loaded and may expand quickly when removing it.

Stopper pin

ENGLISH

BEFORE YOU OPERATE THE MONITOR 5