Iiyama B1706S, E1706S user manual Special Notes on LCD Monitors, Customer Service, Cleaning

SPECIAL NOTES ON LCD MONITORS

The following symptoms are normal with LCD monitors and do not indicate a problem.

NOTE When you first turn on the LCD monitor, the picture may not fit in the display area because of the type of computer that is used. In this case, adjust the picture position to the correct position.

Due to the nature of the backlight, the screen may flicker during initial use. Turn off the Power Switch and then turn it on again to make sure the flicker disappears.

You may find slightly uneven brightness on the screen depending on the desktop pattern you use.

Due to the nature of the LCD screen, an afterimage of the previous screen may remain after switching the image, when the same image is displayed for hours. In this case, the screen is recovered slowly by changing the image or turning off the Power Switch for hours.

Contact your dealer or iiyama service center for the backlight replacement when the screen is dark, flickering or not lighting up. Never attempt to replace it by yourself.

CUSTOMER SERVICE

NOTE	The fluorescent light used in the LCD monitor may have to be periodically replaced.
	For the warranty coverage on this component, please check with local iiyama
	service center.
	If you have to return your unit for service and the original packaging has been
	discarded, please contact your dealer or iiyama service center for advice or
	replacement packaging.

CLEANING

WARNING If you drop any materials or liquids such as water into the monitor when cleaning, unplug the power cable immediately and contact your dealer or iiyama service center.

CAUTION For safety reasons, turn off the power switch and unplug the monitor before you clean it.

NOTE	To protect the LCD panel, do not scratch or rub the screen with a hard object.
	Never use any of the following strong solvents. These will damage the cabinet and
	the LCD screen.	Spray-type cleaner
	Thinner
	Benzine	Wax
	Abrasive cleaner	Acid or Alkaline solvent
	Touching the cabinet with any product made from rubber or plastic for a long time
	may cause degeneration or loss of paint on the cabinet.
CABINET	Stains can be removed with a cloth lightly moistened with a mild detergent solvent.
	Then wipe the cabinet with a soft dry cloth.
LCD	Periodic cleaning with a soft dry cloth is recommended.
SCREEN	Don't use tissue paper etc. because these will damage the LCD screen.

ENGLISH

FOR YOUR SAFETY 3