
Lubricants
1. Ikelite provides silicone lubricant with the housing.
We recommend that you use only Ikelite lubricant on Ikelite products as some other brands may cause the o’ring to swell and not seal properly.
2. Use only enough lubricant to lightly cover control shafts and o’rings. Wipe off any excess lubricant with a clean cloth. Lubricant is not a sealant, it is used to reduce friction. Excessive lubricant can collect sand and dirt which may interfere with proper sealing.
CAUTION
Never use spray lubricants as the propellant ingredient can cause the plastic housing to crack.
Lens Port
Treat the glass in the lens port as a camera lens. After use, rinse and gently dry the lens port to avoid water spotting. To clean use a mild soap solution or lens cleaner.
Do not use alcohol or window cleaner on the Lens Port.
Using Flash
Using the Camera’s Built-in Flash.
If you do not have an external flash the camera’s
External Substrobes
External strobes offer several advantages over using the camera’s
Using an External Flash with Sync Cord.
This camera and housing can use any Ikelite Substrobe, in the Manual Mode when connected with a #4103.51 sync cord. Substrobe 50
Substrobe DS50
Substrobe DS51
Substrobe 100A
Substrobe DS125
Substrobe 200
Strobes do not work TTL with this housing.
9
10
Using an External Flash with the EV-Controller
This camera and housing can utilize the Ikelite
Using the
Sync Cord #4103.51
The
Using Flash Cont.
Using the
When using an external flash with the
This edge against housing
Deflector material
#4103.51 eliminating the need to use the camera’s
Camera Menu settings when using the
a sync cord.
Go to Speedlight Options, Pop Up set to Auto, Speedlight Control set to Internal Off.
Installing Deflector
To install the Deflector spread the port clamp at the
spring end and slide over the lens port. The white plastic
should be placed in front of
the camera flash. The port clamp should be pushed back against the front of the housing.
Using Dual Substrobes
For dual strobes the #4103.52 dual sync cord can be used or the second strobe can be slaved using the Ikelite Remote TTL Slave #4100.5.
NOTE:
Ikelite Substrobes manufactured before June 1, 2001 require a modification to be used in a two strobe
11 | 12 |
|