The spa jet unit features an automatic filter cycle and |
| DRAINING THE PUMP | |
freeze protection. If the spa jet unit has not been |
|
| |
operated for three hours, the pump will begin circulat- |
| After the spa is drained (see DRAINING THE SPA | |
ing the water for twenty minutes to filter any impuri- |
| above), the pump in the dry side jet pack should also | |
ties. Also, if the water temperature falls below 40°F, |
| be drained if the spa will be stored for more than thirty | |
the pump will begin circulating and heating the water |
| days, or if it may be exposed to freezing tempera- | |
to prevent the water from freezing. |
| tures. To drain the pump, follow these steps: | |
DRAINING THE SPA |
| • Remove the pillow from the wet side jet pack | |
|
|
| • Unscrew the two threaded collars (see assembly |
To drain the spa, you must use a garden hose to |
| step 4) connecting the dry side jet pack to the wet | |
siphon the water. Place one end of the hose in the |
| side. | |
spa and hold it in front of a hydrotherapy jet until |
| • Remove the filter cap | |
there is a flow of water coming out of the hose. | Turn | • Remove the six screws securing the Dry Side Shell | |
off the spa unit and unplug the power cord. The |
| (15) to the dry side jet pack. | |
unit will be damaged if it is run without water cir- |
| • Locate the pump inside the spa jet unit. | |
culating. | Be sure the end of the hose in the spa is on |
| • The nut on one side of the pump must be |
the floor of | the spa. |
| unscrewed and the unit must be tipped on its side |
• Rock the spa jet unit slightly, until all the water has drained from the pump.
• Replace the nut on the pump
• Replace the dry side shell, filter cap and pillow
USING THE CONSOLE
Refer to the console diagram at the right. The function of each console control is explained below:
Thermostat: Controls the temperature of the water. The thermostat can be set to heat the water from 70°F to 104°F. Use a medical or other accurate ther- mometer to check the temperature of the water.
On/Off Button: Turns the spa jet unit on and off and changes the operation mode of the spa. The spa has
three modes of operation:
•Auto Heat
•Soak
•Hydrotherapy
When your spa is in the auto heat mode, pushing the button once will cause it to go into soak mode for 20 minutes. Pushing the button twice will cause the spa
to go into hydrotherapy mode (the jets will be running) for 20 minutes. If your spa is not heating, pushing the button once will cause it to go into hydrotherapy
mode. Pushing the button again will switch to soak mode.
The spa jet unit also features an automatic mode, which heats and filters the water when the spa is left unattended. When the spa jet unit is first plugged in, or if the on/off button on the console has not been pressed for longer than three hours, the automatic
Thermostat |
On/Off Button |
mode will begin filtering or heating the water, as need-
ed. Note: To keep the filter and heat cycles from running, the power cord must be unplugged.
The On/Off button has a
12
