Assembly
Before beginning assembly, carefully read the following information and instructions:
•Place all parts in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed.
•Read all assembly steps before you begin.
•Assembly requires only the included air pump. Note: The included flat wrench is not required for assembly. The flat wrench is used to remove the filter cap (see pages 10 and 11).
•Make sure that all parts are oriented as shown in the drawings.
1. Before beginning assembly, be sure that you | 1A |
| |||
have read and understand the information in the | 29 | ||||
| |||||
box above and on page 6. |
|
| |||
|
|
| |||
Place the Surround Bottom (45) and the pre- |
|
| |||
attached Spa Surround (9) on the ground in the |
| Holes | |||
location you have chosen for assembly. Unfold the |
|
| |||
Spa Surround until it is round. |
|
|
| ||
Open the Inflatable Liner (29). Lay the floor of the |
|
| |||
Inflatable Liner (the side with the triangular pattern) |
|
| |||
on the bottom of the Spa Surround (9). Pull the liner |
|
| |||
wall up, | making sure that the three indicated |
|
| ||
holes in the Inflatable Liner are centered in the |
|
| |||
cutout in the Spa Surround | . |
|
| ||
|
|
|
| Cutout | |
|
|
|
| Fastener | |
|
|
|
| Strip | |
|
|
|
| 9 | |
|
|
|
| 45 | |
Attach the flap on the top edge of the Inflatable Liner | 1B | View from the Outside | |||
(29) to the fastener strip on the edge of the Spa | |||||
| Holes in Inflatable Liner | ||||
Surround (9). Start the flap where the fastener strip |
| ||||
starts and pull the flap tight as you go around. | Make | Cross | |||
sure the three holes in the Inflatable Liner are |
| ||||
centered in the cutout in the Spa Surround (9), |
| Section | |||
as shown in the inset drawing. |
|
|
| ||
|
|
|
| Cutout | |
|
|
|
| 29 | |
|
|
|
| Flap | |
|
|
|
| 9 | |
|
|
|
| Fastener Strip | |
|
|
| 7 |
| |
