![](/images/new-backgrounds/1098633/9863345x1.webp)
THE MINELAB EXPLORER II
Figure 2.8 Inserting shaft assembly
into control box
STEP 5 Secure upper shaft in position by locking the control box camlock.
STEP 6 (Figure 2.9) Adjust shaft to the desired length and then lock with shaft camlock lever.
STEP 7 (Figure 2.9) Tilt the search coil to the most comfortable angle, keeping in mind it will need to be parallel to the ground during detecting.
NOTE To avoid difficulty securing the control box camlock lever, ensure the shaft camlock is released to allow greater shaft movement.
You are now ready to proceed to the handle assembly.
Figure 2.9 Adjusting the shaft and angle of the search coil
Coil not connected?
$
These instructions require the
search coil to be connected to the lower shaft. For directions on this procedure, refer to page 13.
CONNECTING THE SHAFT ASSEMBLY
23