Minelab Mine lab Explorer IITM, P0591-A manual Fitting the armrest strap

		THE MINELAB EXPLORER II
		Fitting the armrest strap
		Figure 2.11–2.13
		To fit and adjust the armrest strap:
		STEP 1 (Figure 2.11) Thread the strap through the buckle openings
		as illustrated.
		STEP 2 (Figure 2.12) Clip both buckles into the openings at each
Figure 2.11	Fitting buckle to armrest strap	outer side of the armrest.
		STEP 3 Test by sliding your arm underneath the strap and resting
		your forearm on the armrest (which should be adjusted to a
		comfortable setting).
		STEP 4 (Figure 2.13) Loosen strap by tilting the edge of the buckle
		out to release it from the armrest. Undo the velcro and pull
		the buckle outwards (towards yourself). Clip the buckle back
		into place and tighten the strap by pulling up (in the direction
		of the top arrow in Figure 2.13).
		The armrest should now be adjusted to your satisfaction. Next time
		you use your detector, all you will need to do is click the buckle back
		into the armrest.
Figure 2.12	Fitting armrest strap to
armrest
Figure 2.13	Tightening armrest strap
		25
		THE HANDLE ASSEMBLY