Image IMBE39401 user manual

10.Locate the High Cable (84), which is slightly longer than the Low Cable (not shown), and notice that there is a ball on one end of the Cable and a metal sleeve on the other end.

Route the metal-sleeve end of the High Cable (84) up under the lat bar rest on the Weight Guide Frame (14), down through the indicated hole, back up through the next hole, and then down between the Weight Guides (9) as shown.

11.Insert the end of the High Cable (84) into the hole in the center of the Weight Carriage (15). Attach the Cable using a M10 x 66mm Bolt (35), two M10 Washers (37), two 24mm Spacers (38), and an M10 Nylon Locknut (29).

12Lift the High Cable (84) in the location shown. Attach two Pulleys (24) inside the bracket on the Weight Guide Frame (14) using two M10 x 50mm Bolts (86) and two M10 Nylon Locknuts (29).

13.Lift the High Cable (84) in the location shown. Attach two Pulleys (24) inside the Weight Guide Frame (14) using two M10 x 72mm Bolts (34), four M10 Washers (37), four 18mm Spacers (85), and two M10 Nylon Locknuts (29).

10			14
Lat Bar			9
Rest
84
11
	37	38	84
	29
			38
			37
	15		35
12	24
			84
	29		14
			86
13	24
37			84
	85		14
29
37			85
			37
85			34
	85
	37

9