11.Locate the Lower Cable (39) and note that it has a ball/loop on one end and a loop only on the other. See drawing 11a. Route the end of the Lower Cable with the loop through the cable guide on the outside of the Right Upright (2).
See drawing 11. Route the Lower Cable (39) around a Pulley (35) in the direction shown. Attach the Pulley and one end of the
Do not tighten the Nylon Locknut yet. Make sure that the Support Plate is angled as shown and that it is attached on the inside of the Upright (2).
Important: The Cable must be positioned between the Pulley and the welded pin as shown in draw- ing 11a.
12.Wrap the Lower Cable (39) around a Pulley (35) in the direction shown. Attach the Pulley and a Cable Trap (61) to the lower set of holes in the two Pulley Plates (62) with an M10 x 48mm Bolt (55) and an
M10 Nylon Locknut (11). Make sure that the Cable
Trap is between the Pulley Brackets and that it is oriented as shown.
Slide the loop on the Lower Cable (39) onto an M10 x 68mm Bolt (33). Insert the Bolt into the indicated hole (see drawing 11a) in the Right Stabilizer (26) and through the
IMPORTANT: The type of cable used on the weight bench may stretch over time. If this occurs, you can tighten the cables by moving the lower Pulley (35) attached to the Pulley Plate (62). To do this, remove the M10 x 48mm Bolt (55) and the M10 Nylon Locknut (11). Move the Bolt to one of the higher adjustment holes in the Pulley Plates. As you
Go back and tighten all of the M10 Nylon Locknuts (11) used in steps 1 through 12.
10
11 | 35 | 2 |
|
| |
| 71 |
|
39 |
|
|
| Welded Tube |
|
|
| 74 |
|
| 11 |
11a | 2 |
|
|
| |
|
| 39 |
| 35 |
|
| Welded Pin |
|
Hole for End of Cable | Cable Guide | |
12 | 55 |
|
|
| |
| Adjustment | 62 |
|
| |
| Holes | 11 |
|
| |
| 35 | 61 |
|
| |
| 1 |
|
|
| 39 |
| 33 |
|
|
| 26 |
| 74 | 11 |
