Image IMBE40890 manual Locknuts yet

2.Press a 2Ó Square Outer Cap (58) onto each end of the Left Stabilizer (25).

Press a 51mm x 76mm Inner Cap (24) into the top of the Left Upright (1).

Insert two M10 x 62mm Carriage Bolts (59) into the holes in the Left Stabilizer (25) from below.

Slide the Left Upright (1) onto the Left Stabilizer (25) as shown, so the bracket on the Left Upright fits over the M10 x 62mm Carriage Bolts (59) in the Left Stabilizer.

Attach the Left Upright (1) to the Left Stabilizer (25) with an M10 x 65mm Bolt (67), two M10 Washers (6), and an M10 Nylon Locknut (11). Thread an M10 Nylon Locknut onto each of the M10 x 62mm Carriage Bolts (59) in the Stabilizer. Do not tighten the Nylon Locknuts yet.

3.Align the holes in a 4-hole Support Plate (16) with the holes in the Right Upright (2). Insert four M10 x 72mm Bolts (68) into the Support Plate and the Right Upright. Make sure that the Bolts are inserted from the direction shown.

Align the holes in another 4-hole Support Plate (16) with the holes in the Left Upright (1). Insert four M10 x 72mm Bolts (68) into the Support Plate and the Left Upright. Make sure that the Bolts are inserted from the direction shown.

While a second person holds the Right Upright (2), slide the bracket on the Crossbar (20) over the four M10 x 72mm Bolts (68) in the Right Upright. Make sure that the Crossbar is turned so the warning decal is on top. Attach the Crossbar with four M10 Nylon Locknuts (11). Do not tighten the Nylon

Locknuts yet.

Attach the Crossbar (20) to the Left Upright (1) as described above.

2		24
		1
		11
	11	58
	67
	6
	6	25
	58
		59
3
	2
68	16	1
68	Decal
	11	11
	11
	20	68
	11
		16
		68

7