5.Attach the nozzle on the air pump to the valve on the floor of the Inflatable Liner (29). Use the air pump to fill the bottom of the Inflatable Liner with air. Be extremely careful not to puncture the
Liner. You will need to operate the pump by hand for this step.
Attach the nozzle on the air pump to the valve on the bolster of the Inflatable Liner (29). Fill the bol- ster until there are no wrinkles left.
6.Before you fill the RENEW 815 with water, make sure it is in the position you want, and that it can easily be serviced. Also, make sure you can easily remove the cover. Once the RENEW 815 is filled with water, it will need to be drained to be moved.
Using a garden hose or other clean water source, begin filling the RENEW 815 until you have 2 to 3 inches of water in the spa. At this point it is very important to smooth out any wrinkles in the Inflatable Liner (29). It is normal to have a few wrinkles, but make sure you smooth out as many wrinkles as possible from the sides and the bottom of the Liner.
When most of the wrinkles are gone, keep filling the spa until the water reaches the fill line. Do not overfill the RENEW 815. After the RENEW 815 is full, you must prime the spa jet unit before using the RENEW 815 (see PRIMING THE SPA JET UNIT on page 10). Note: Prime the jet unit before performing step 6.
7.Use the air pump to fill both chambers of the Inflatable Cover (4) with air. Slide one of the straps on the inside of the Spa Cover (11) through one of the loops on the Inflatable Cover. Attach the latch on the strap to the buckle on the other end. Attach the other three straps on the inside of the Spa Cover through the loops on the Inflatable Cover in the same manner.
8.Place the Spa Cover over the spa and line up the bulge on the Inflatable Cover with the Console on the dry side jet pack. Snap each of the six latches on the Spa Cover into the buckles on the wood sur- round.
9
5 | 29 | Air Valve |
| ||
|
| Air Valve |
6 | 29 |
|
| Fill Line | |
|
| |
7 |
| Air Valve |
|
| |
| 4 |
|
|
| Pouch for |
| 11 | Jet Plugs |
|
| |
|
| Latches |
|
| and Buckles |
8 |
| Bulge |
|
| Console |
|
| Latch |
|
| Buckle |
