2.Orient the dry side jet pack (A) as shown and posi- tion it next to the three holes in the Inflatable Liner (29).

Attach the Temperature Probe Assembly (30) to the small hole in the Inflatable Liner (29). To do this, place the Temperature Probe Gasket (46) over the Probe connector threads. Insert the wire (not shown) through the hole, then push the Temperature Probe through the hole. Make sure the threads on the con- nector have been pushed fully through the vinyl liner. Thread the Temperature Probe Nut (47) onto the connector and make sure it is tight. Connect the wire from the Temperature Probe to the receptacle on the dry side jet pack (A).

3.Move the dry side jet pack (A) up against the wall of the tub. Pull the two connectors on the dry side jet pack through the large holes in the Inflatable Liner (29). Push a Wet Side Gasket (48) onto each con- nector. Thread a Wet Side Nut (49) onto each con- nector and make sure it is tight.

4.Position the wet side jet pack (B) as shown. Place an O-ring (52) in the groove of each connector on the wet side jet pack. Note: Make sure the O-rings are placed securely in the groove (see drawing 4A).

Attach the threaded collar on the right side (as seen on drawing 4A) of the wet side jet pack (B) to the corresponding connector on the dry side jet pack

(A). Attach the left side in the same manner. Note: If the threaded collars are not tightened fully, the spa will not function.

Position the Pillow (26) over the hole on the top of the wet side jet pack (B). Push the fasteners on the Pillow through the appropriate holes in the wet side jet pack.

8

2

 

Small

A

 

 

29

 

 

Hole

 

 

 

 

 

 

 

 

 

Receptacle

46

 

 

 

 

30

 

 

47

 

 

 

 

 

 

 

 

9

 

3

 

 

29

 

 

 

 

 

 

 

 

Connectors

A

 

 

 

 

 

 

48

 

 

 

49

48

 

 

 

 

 

 

 

 

 

9

4

 

 

 

 

 

 

 

O-rings (52)

A

 

 

 

 

 

 

26

 

 

 

B

 

 

 

29

 

 

 

 

4A

View of Inside of Wet Side Jet Pack

 

 

 

 

O-rings (52)

 

 

 

 

Threaded Collar

 

Page 8
Image 8
Image IMHS81590 manual Rings Threaded Collar