The following table shows the function for each of the eight Dip switches
on FiberLinX. Refer to the section on each feature for specific configuration
information.
Switches 1 & 2: Fiber Optic Type
These Dip switch settings are configured at the factory and should NOT
be changed in the field.
Switches 3 & 4: Selecting Duplex Mode
Each data port on FiberLinX can operate in either Half-Duplex (HDX) or
Full-Duplex (FDX) Mode. (NOTE: The Twisted Pair management port is
ALWAYS Half-Duplex.) You will need to set the duplex mode of these ports
depending on the capabilities of the connected hardware.
FiberLinX is shipped from the factory with HDX selected on each data port
(i.e., Dip switches 3and 4in the OFF position). Select FDX for the fiber
data port by setting Dip switch 3to ON. Select FDX for the twisted pair data
port by setting Dip switch 4to ON.
Switches 5 & 6: SNMP Management Traffic
Although FiberLinX provides a twisted pair port solely for management
traffic, you can configure FiberLinX to accept SNMP management traffic from
any of its three ports. There are four different ways you can configure
FiberLinX to accept (or not accept) SNMP management traffic. Only one
source for SNMP management traffic can be active at any time, and only the
SNMP management traffic directed to the moduleî‚’s IP address will be
accepted.
FiberLinX is configured at the factory to accept SNMP management traffic
from the twisted pair data port (i.e., Dip switch 5ON, Dip switch 6OFF).
You can change this setting by adjusting Dip switches 5and 6. The
following table shows the switch settings for each configuration.
2.2
FIBERLINX DIP SWITCH GUIDE
Switch
1
2
3
4
5
6
7
8
Feature
DONOT CHANGE
DONOT CHANGE
Enables Full-Duplex mode on the Fiber Data port
Enables Full-Duplex mode on the Twisted Pair Data port
Specifies from which port SNMP traffic is accepted
Specifies from which port SNMP traffic is accepted
Configures
FiberLinX
as a Remote unit
Configures
FiberLinX
as a Host unit
Default
Varies
Varies
OFF
OFF
ON
OFF
OFF
OFF