9) As stated earlier, the Networking Control Panel application will
launch once you finish the Setup Utility. Here you must install
the drivers necessary for running HUBCTRL32. At this window,
do the following:
For Windows 98 Network Control Panel Application
A) Highlight an adapter to bind HUBCTRL32 to.
B) Click the Add... button.
C) Select Protocol from the list then click the Add...
button.
D) Click Have Disk..., then Browse.
E) The install INF and packet drivers can be found in the
directory C:\Program Files\Hub Control32 or the
directory specified in the Choose Destination Location
dialog box (see 4, above). Select this directory,
highlight the file SNMPpkt.inf and click OK, then click
OK again.
F) The correct directory for the driver will already be
displayed, click OK to install the new driver.
G) Restart the system to complete the HUBCTRL32
installation.
For Windows NT Network Control Panel Application
You MUST have Administrator rights to perform the
following steps. If you do not you will need to LOGOFF and
LOGON on as Administrator.
A) Click the Protocols tab.
B) Click the Add... button, then Have disk...
C) Enter C:\Program Files\Hub Control32 or the directory
specified in the Choose Destination Location dialog
box (see 4, above) in the box, then click OK.
D) Click OK to select the SNMP Ndis3 protocol.
E) Click Close...to bind the new protocol.
F) Restart the system to complete the HUBCTRL32
installation.
If you experience any problems, please contact IMC Networks technical
support at (800) 624-1070 (in U.S.), +32-16-550880 (Europe) or via e-mail
at techsupport@imcnetworks.com
For information regarding the use of HUBCTRL32, please refer to the
HUBCTRL32 online Help file (Start, Programs, Hub Control32).
Ap.6