STEP 5 (See Diagram 5 & Cable Loop Diagram)

A.)

Attach the 283” Upper Cable (#48) to the swivel pulley pre-installed in the front of the

 

Right Lat Bar Frame (#9). Install a Ball Stopper (#46) onto the end of the Cable.

 

Attach the U-shaped Connector (#28) to the end of the Cable.

B.)

Attach a Short Chain (#30) in between the openings on the Connector and secure it

 

with a M10 x 1 3/8” Allen Bolt (#59), two ¾” Washers (#64), and one M10 Aircraft Nut

 

(#66).

C.)

Draw the Cable over the Pulley and pull through the Cable sleeve on the Right Lat Bar

 

Frame. Draw the Cable along the Frame towards the back of the machine to the Pulley

 

previously installed. Draw the Cable around the Pulley then downward to the Double

 

Floating Pulley Bracket (#24).

D.)

Attach two Pulleys (#36) to the Bracket. Secure them with a M10 x 2 ¾” Allen Bolt

 

(#55), two Ø ¾” Washers (#64), and one M10 Aircraft Nut (#66).

E.)

Draw the Cable around the back Pulley then upward to the bottom of the Lat Bar Frame

 

Bracket (#20). Install a Pulley.

F.)

Draw the Cable around the Pulley then back down to the Double Floating Pulley

 

Bracket (#24) again. Let the Bracket hanging for now.

G.)

Draw the Cable around the front Pulley then upward towards the Pulley on the Left Lat

 

Bar Frame (#10).

H.)

Draw the Cable over the Pulley then along the Left Lat Bar Frame (#10) towards the

 

front of the machine. Insert the Cable through the Cable sleeve and over the pre-

 

installed Pulley on the front of the Left Lat Bar Frame.

I.)

Install a Ball Stopper (#46) at the end of the Cable and attach a U-shaped Connector

 

(#28) to the end. Attach a Short Chain (#30) in between the openings on the Connector

 

and secure it with a M10 x 1 3/8” Allen Bolt (#59), two ¾” Washers (#64), and one

 

M10 Aircraft Nut (#66).

J.)

Connect the Lat Bar (#11) or Single Handles (#33) to the Short Chains using C-clips

 

(#32).

12

Page 13
Image 13
Impex MD PWR-8 manual See Diagram 5 & Cable Loop Diagram